Product for fastening, mounting, conjoining, and adhesive bonding works, two-component. Code of conformity: 04.613/8-e.

This solution can be applied in the following areas:

• arrangement of all types of fastening components;
• repair and insulation of cracks formed in concrete;
• cementing of cracks;
• insulation of cracks;
• conjunction of different metal and concrete structures;
• adhesive bonding of metal and steel-made details.

• does not contain soluble substances in its composition;
• easy use and application;
• high mechanical strength;
• waterproof;
• high adhesive quality provided for concrete and steel surfaces.

Preparation of the surfaces. Cement based surfaces (concrete, plaster, etc.) or layers should be cleaned from all contaminations. Metal surfaces should be totally cleaned from rust and contaminations.

Preparation of the mixture. The EPOKS 300 product is two-component joint filling mixture, so it has been packed in corresponding amounts. At the time of application both components should be mixed during at least 3 minutes using 400-600 RPM mixer till the mixture is entirely homogeneous. During the mixing process +150C to +250C temperature of the solution should be provided.

Mixture preparation proportions:

Component A: epoxide resin 3.75 kg;

Component B: epoxide based hardening agent 1.25 kg.

Application. Spread the EPOKS 300 product over the surface using trowel. Thoroughly clean the holes in reinforcing fitting structures by compressed air. The width of opened holes should not exceed the width of joined components more than by 6mm. The product can be applied easily using spray gun.

Recommendations. The EPOKS 300 solution should be mixed using a suitable mixing unit. The mixture should be thoroughly mixed by hands or using trowel. Period of use and hardening of products containing solution of epoxide resins depends on the ambient temperature. The most effective operating temperature range is +100C - +200C. The prepared mixture in no case should be diluted with water or fresh solution. After use all hand tools and devices should be cleaned with warm water with addition of powdered detergent.

The amount of consumed repair mixture changes depending on the form and depth of cracks.

The product can be stored during 12 months packed in original sacks in dry and cold conditions, provided freezing is avoided.

• ventilate the area of application of the EPOKS 300 repair mixture until the repair works are completed;
• when using the product observe regulations of operational and personnel safety, wear appropriate protective clothing, safety gloves, glasses, and respirators;
• taking into consideration that the solution can cause allergic reactions and itch, take care to avoid contact of its components with skin or eyes, otherwise immediately rinse them with large amount of water and wash with soap;
• in case you swallow the product, immediately consult a physician;
• do not keep food products in the areas of the solution application;
• keep the product away from children;

• information indicated in technical specifications is based on scientific and experimental data;
• Matanat А company is responsible for the product quality only;
• with the exception of cases of works executed under the supervision of the company specialists, Мatanat А company shall not be liable for any problems occuring due to improper use of the product by other persons;
• the company reserves the right to make changes in its product in consequence of scientific-and-technical development;
• for technical support and or more information please do not hesitate to contact the Matanat А company!