Acrylic heteropolymer emulsion based paste for internal and external surfaces and building facades.

This facing paste can be applied in the following areas:

• repair of concrete, plaster, flooring plaster, and other similar surfaces inside buildings and on building facades;
• filling cracks on surfaces.

• creates strong primer layer for paints applied onto surfaces, and provides saving of paint materials;
• resistant to environmental impact, environmentally friendly, odorless, easily applicable, ready for application;
• easily applicable inside buildings and on building facades;

Preparation of the surface. The surface to be treated should be firm, dry and clean. The surface should be free of residues deteriorating adhesive force, it should be checked for strength. Prior to application of the product, the surface should be dampened or should be primed with Binmader primer to achieve better results.

Application. The product should applied without adding water because it is produced ready for application. The product can be applied onto the surface using trowel, any paste spreading tool like applicator, or spray gun. The layers should be applied at least in 3-4-hour intervals, and to obtain smooth surface 2-3 layers should be applied. The paint should be applied using brush or roller. During application the surface temperature should be above or equal to +50C.

Recommendations. At the time of application of the F-pas facing paste the surface temperature should be within +50C - +300C. In case of outdoor application the surface should be protected from direct sun rays, rain, wind and frost for 24 hours.

To fill deep cavities and cracks on the building facades it is recommended to add 250 g of white cement and approximately 100 g of water to 1 kg of F-Pas facing paste, and to apply onto the surface after thorough mixing. This procedure will  form stronger surface.

Depending on surface conditions 1 kg of F-Pas facing paste may cover 0.8-1.2 m²  surface.

The product can be stored 12 months packed in closed buckets in dry conditions.

• taking into consideration that F-Pas facing paste contains complex chemical compounds, immediately rinse it with water in case of contact with skin or eyes;
• do not add any substances not indicated in the application instructions;
• parameters indicated above have been received on the basis of laboratory tests conducted in the ambient conditions of +230C±20C temperature and 50% +5% humidity. Depending on the actual ambient conditions these parameters are subject to change.

• information indicated in technical specifications is based on scientific and experimental data;
• Matanat А company is responsible for the product quality only;
• with the exception of cases of works executed under the supervision of the company specialists, Мatanat А company shall not be liable for any problems occuring due to improper use of the product by other persons;
• the company reserves the right to make changes in its product in consequence of scientific-and-technical development;
• for technical support and or more information please do not hesitate to contact the Matanat А company!