Hydrocarbon based product to be applied onto freshly poured concrete and Staltop surfaces by means of spraying. The product retains required degree of moisture in the concrete, and provides obtaining even surface preventing shrinkage of concrete treated surfaces and formation of small cracks, as it elongates the fast hardening period.

This product can be applied in the following areas:

• In addition to retaining water and moisture in concrete, the product can be cost-effectively and successfully applied on any concrete surfaces;
• Air ports;
• Vehicle parking areas;
• Road and water channel concrete;

• Can be applied to all required types of concrete surfaces;
• Creates more uniform and smooth surface, without bubbles and porosity;
• The product creates waterproof surfaces;
• Smoother and stronger;
• Prevents occurrence of small imperceptible cracks resulting from hardening;
• Easy and simple application;
• Reduces operating expenses, cost-effective.

Preparation of the surface. Before application of the МА Kur 300 product the surface should be thoroughly cleaned.

Application. Spray the МА Kur 300 product onto freshly poured concrete surface to provide as equal thickness as possible, or apply it onto the surface using a roller. In case the МА Kur 300 product is applied onto the concrete in formworks the spraying procedure should be started immediately after loss of gloss by the concrete surface (after removal of the formwork).

Recommendations. If at the time of the МА Kur 300 product application the ambient temperature exceeds the limits of +50C - +300C range, then the required temperature level should be provided. The product should not be used in warm (above +300C), rainy and windy weather conditions. After use all hand tools and devices should be cleaned with water.

170 gram of the МА Kur 300 product is enough to treatment 1 m2 surface.

The product can be stored during 12 months in original sacks in dry conditions

• taking into consideration that the product contains chemical substances, immediately rinse it with water in case of contact with skin or eyes;
• do not add any substances not indicated in the application instructions;
• parameters indicated above have been received on the basis of laboratory tests conducted in the ambient conditions of +230C±20C temperature and 50% +5% humidity. Depending on the actual ambient conditions these parameters are subject to change.

• information indicated in technical specifications is based on scientific and experimental data;
• Matanat А company is responsible for the product quality only;
• with the exception of cases of works executed under the supervision of the company specialists, Мatanat А company shall not be liable for any problems occuring due to improper use of the product by other persons;
• the company reserves the right to make changes in its product in consequence of scientific-and-technical development;
• for technical support and or more information please do not hesitate to contact the Matanat А company!