Paraffin based solution applied onto freshly poured concrete and Staltop surfaces by means of spraying. The solution creates a layer on the treated surface. This layer retains required degree of moisture providing full hydration of cement. The МА Kur 100 product prevents shrinking of treated concrete surface during the period of hardening, as well as on this reason small cracks do not occur on the surface. As a result an even surface is formed.

This product can be applied in the following areas:

• In addition to retaining water and moisture in concrete, the product can be cost-effectively and successfully  applied on any concrete surfaces;
• Air ports;
• Vehicle parking areas;
• Road and water channel concrete;

• Satisfies demand of concrete in water;
• Easy applicable;
• Reduces operating expenses;
• Creates more uniform and smooth surface without porosity;
• The product forms waterproof layer;
• Prevents occurrence of imperceptible cracks resulting from hardening;
• Reflects sunrays and retains high degree of moisture in freshly poured concrete and Staltop.

Preparation of the surface. Before application of the МА Kur 100 product the surface should be thoroughly cleaned, regardless from its conditions.

Application. Spray the МА Kur 100 product onto freshly poured concrete and Staltop surface to provide as equal thickness as possible. In case the product is applied onto horizontal surfaces start spraying procedure immediately after loss of gloss by the concrete surface. In case the product is sprayed onto the concrete in formworks, the process should be started immediately after removal of the formworks.

Recommendations. If at the time of the МА Kur 100 product application the ambient temperature exceeds the limits of +50C- +300C range, the required temperature level should be provided. The product should not be used in warm (above +300C), rainy and windy weather conditions. After use all hand tools and devices should be cleaned with water.

1 liter of the МА Kur 100 product is enough to treat 5.6 m2 surface.

The product can be stored during 12 months in original sacks in dry conditions

• taking into consideration that the product contains chemical substances, immediately rinse it with water in case of contact with skin or eyes;
• do not add any substances not indicated in the application instructions;

parameters indicated above have been received on the basis of laboratory tests conducted in the ambient conditions of +230C±20C temperature and 50% + 5% humidity. Depending on the actual ambient conditions these parameters are subject to change.

• information indicated in technical specifications is based on scientific and experimental data;
• Matanat А company is responsible for the product quality only;
• with the exception of cases of works executed under the supervision of the company specialists, Мatanat А company shall not be liable for any problems occuring due to improper use of the product by other persons;
• the company reserves the right to make changes in its product in consequence of scientific-and-technical development;
• for technical support and or more information please do not hesitate to contact the Matanat А company!