Based on emulsion polymer, ready for application product increasing mechanical strength, elasticity, adhesive force, waterproofing features, contains substances preventing formation of cracks and erosion.

This waterproofing mixture can be applied in the following areas:

• Increasing of mechanical strength, elasticity, adhesive force, waterproofing features of:
• cement based concrete;
• plaster;
• flooring plaster;
• MATON and Filkret mixtures;
• preventing formation of cracks and erosion.

• The product does not form cracks during application and afterwards;
• Increases efficiency;
• Provides saving of materials consumption.

Preparation of the surfaces. The surface should be totally free of any substances deteriorating adhesive force.

Preparation of mixture. Rinse the  MA Latex solution before use. To provide waterproofing features of the surface mix the MA Latex waterproofing solution diluted with water at proportion of 1/1 - 1/4  (MA Latex/water). To prevent formation of cracks and water soaking add the MA Latex waterproofing solution, diluted with water at proportion of 1/1- 1/4  (MA Latex/water), into tile adhesives, repair plasters, and other construction mixtures.

Application. Spread the prepared mixture according to the instruction

On the cement based surfaces: 150 g/m2  is applied.

The product can be stored during 12 months packed in original sacks in dry conditions.

• when using the product observe regulations of operational and personnel safety, wear appropriate protective clothing, safety gloves, glasses, and respirators;
• taking into consideration that the product can cause allergic reactions and itch, take care to avoid contact of its components with skin or eyes, otherwise immediately rinse them with large amount of water and wash with soap;
• in case you swallow the product, immediately consult a physician;
• do not keep food products in the areas of the solution application;
• keep the product away from children;
• parameters indicated above have been received on the basis of laboratory tests conducted in the ambient conditions of +230C±20C temperature and 50% + 5% humidity. Depending on the actual ambient conditions these parameters are subject to change.

• information indicated in technical specifications is based on scientific and experimental data;
• Matanat А company is responsible for the product quality only;
• with the exception of cases of works executed under the supervision of the company specialists, Мatanat  А company shall not be liable for any problems occuring due to improper use of the product by other persons;
• the company reserves the right to make changes in its product in consequence of scientific-and-technical development;
• for technical support and/or more information please do not hesitate to contact the Matanat А company!